Search results for "Liquid viscosity"

Liquid viscosity and flow rate effects on interfacial area in packed columns

1989

Abstract The influences of liquid kinematic viscosity and liquid flow rate on effective interfacial area for chemical absorption in a Raschig ring packed column were studied by absorbing carbon dioxide into potassium carbonate-bicarbonate-arsenite solutions. The viscosities of the absorbing liquid were varied by the addition of sugar. Analysis of the data shows that an increase in liquid flow rate increases the effective interfacial area over the whole viscosity range considered. The influence of liquid viscosity is more complex as the interfacial area increases with viscosity for low values, while decreasing at higher viscosities. Two correlations have been developed to express this behavi…

On the factors governing the pressure dependence of the viscosity of moderately concentrated polymer solutions

1982

Viscosity measurements were carried out as a function of pressure and temperature with solutions of polystyrene in eight (endothermal) θ-solvents at the respective critical composition by means of a Searle-type apparatus. A rolling-ball viscometer was used for the investigation of the pure solvents. In all cases the viscosity coefficient increases in a more or less exponential manner when the pressure is raised. For θ-conditions, the volumes of activation of the solutions exceed that of the pure solvent by typically 10–15%. The exact amount of this extra efffect stemming from the presence of the polymer and its variation with temperature can be qualitatively correlated with the heats of mix…

Solid–Liquid Suspensions in Top-Covered Unbaffled Vessels: Influence of Particle Size, Liquid Viscosity, Impeller Size, and Clearance

2014

Particle suspension in liquids is a unit operation commonly encountered in the process industry. Although it is usually carried out in baffled stirred tanks, there are some specific applications where the presence of baffles may be undesirable. In the present work solid-liquid suspensions are investigated in a radially stirred unbaffled tank provided with a top cover. The minimum impeller speed at which all solid particles get suspended (Njs) and the relevant power requirements (Pjs) are assessed. The dependence of these two parameters on physical properties (liquid viscosity, particle concentration, and size) and system geometrical configurations (impeller diameter and clearance) is invest…

No-flow temperature and solidification in injection molding simulation

2011

The no‐flow temperature (NFT) is a parameter representing the rheological solidification temperature of a polymer. A polymer, during injection molding filling stage, can stop its flow because of its high viscosity, although it is not yet fully solidified by means of glass transition or crystallization. The NFT is used in most of injection molding simulation packages: with this simple parameter it is possible to reduce the errors deriving from viscosity extrapolation at relatively low temperatures. The viscosity measurements for polymers are usually carried out at high temperatures, and the viscosity models can fail in prediction at temperatures close to the glass transition or crystallizati…

1979

Pressure influences on the viscosity of polymer solutions

1982

Of all physico-chemical quantities characterizing the behavior of liquids, the viscosity coefficient η is normally most sensitive to pressure. Early measurements of η(p) date back almost 100 years [1] but they were carried out with very different objectives [2]. Currently, one is particularly interested in polymer solutions, for instance because of the additives to motor oils and of oil recovery. The present paper reports on measurements with polystyrenes of high molecular uniformity in eight different solvents. It confines itself to zero-shear viscosities and discusses the possibilities of discovering the influence of pressure via the molecular structure of the solvent and via its thermody…